500 GPH manual bilge pump removes water from the engine compartment. Runs continuously when switched on. Compact design allows it to fit in tight spaces. Easy installation. Equipped with gasoline-resistant strainer base and 30″ wire leads. NON-AUTOMATIC.
The New Bilge Pump Design Include:
- Rule pumps are tested to the highest standard, achieving r ated performance at 12V vs 13.6V
- Higher Flow – optimized impeller to provide greater flow at the same amperage
- Built-in Thermal Cut-Off (TCO) – provides added protection for pump and vessel
- Back Flow Prevention – reduces the amount of water leftover in the bilge, reducing odor and helping keep your bilge cleaner
- Hidden Air Vents in the Body – helps prevent air locking in challenging plumbing installations and helps with the check valve
- Threaded Discharge – easier installation, easier maintenance
Height: 3.9″ (99mm)
NOTE WHEN USING WITH BILGE PUMP BRACKET: The Rule 25DA bilge pump has a slightly different strainer base than the previously available (and now-discontinued) Rule 25D bilge pump and may not fit all bilge pump brackets. The Blowsion and R&D Racing Bilge Pump Brackets will fit both the original 25D Rule Bilge Pump and the 25DA Rule Bilge Pump.
NOTE: We suggest using an on/off switch with this bilge pump so that it can be shut off when the watercraft is not in use.